Ge nx 6 programming manual

NX-8 KIT Includes NX-8 Control, NXE LED Keypad, V 25VA Transformer NX-8 NX-8 Control Only NXE 8 Zone LED Keypad NXE 16 Zone LED Keypad NXE 24 Zone LED Keypad NXE Alphanumeric LCD Keypad NX ** Zone Doubling Kit (Includes k and k resistors) NX 16 Zone Expander Module. 6 NX-8V2 Control Panel Installation Manual Module list Table 3 below shows some of the modules that are compatible with the NX-8V2 system. Additional information is available from customer support. Table 3: Module list Part number Description NX-8V2 NX-8V2 control only. NX-8V2-KIT NX-8V2 control, NXE LED keypad, V 40 VA transformer. NetworX ™ NX-6 User Manual. to find out how your system is programmed. NX-6 SYSTEM KEYPAD Includes models NXE, NXE, NXE POWER Light is “on” when AC Master Code: A master arm/disarm code that can program other user codes. Partitioned System: A system divided into multiple areas in which its own user or users control each www.doorway.ru Size: KB.

enter the Program Mode using the procedure outlined in the control panel Installation Manual. When the Program Mode is exited, the NX-8 control will automatically enroll the devices. The enrolling process takes about 12 seconds, during which time the AService@ LED will illuminate. User codes will not be accepted during the enrolling process. GE Appliances' owner manuals offer use and care guidelines, installation instructions and feature guides. Also find Quick spec literature and Energy guides. Interlogix NX-4 = Locations (Pages in manual) Interlogix NX-6 = Locations (Pages in manual) Interlogix NX-8 = Locations (Pages in manual) Interlogix NX-8E = Locations (Pages in manual) To turn off the use of resistors for each zone type you will go into the appropriate location.

NX-6 SYSTEM KEYPAD Includes models NXE, NXE, NXE POWER Light is “on” when AC power is present; flashes to indicate a low battery condition. READY Light is “on” when the system is ready to arm; flashes if ready to “force arm”. SERVICE Light is “on” to indicate a trouble condition with your system. ARMED Light is “on. The NX-6 can also be programmed to report an alarm after two or more trips on the same zone. (Loc. 37, 39, 40 and , pg. 19 - 20, 28) Dual / Split / Multiple Reports The NX-6 can send communication reports to three different phone numbers for dual, split or multiple reports selectable by event or partition. (Loc. 4, 10, and 16, pg. ). An extensive tutorial on programming the NX4, NX6, and NX8 Interlogix NetworX panels lt;Back Hi. My name is Jason with www.doorway.ru In today's video, I'm going to be doing the basic programming for the Interlogix NetworX panels. This video will apply to any of the network systems, the NX4, NX6, NX8. They're a.