Futaba gv 1 governor manual

The GV-1 turns off the governor when the engine is starting or idling. *Governor operation = Operation that stabilizes the engine speed at the set speed. Page 11 (Deviation from set speed) The GV-1 stabilizes the engine speed to within +1% of the set speed.  · below), your hobby dealer, or the Futaba Service Center. *S-FHSS: Super- Futaba Frequency Hopping Spread Spectrum Owner’s Manual and Additional Technical Help This manual has been carefully written to be as helpful to you, the new owner, as possible. There are many pages of setup procedures and examples.  · GV-1 Governor Manual (MB) The governor speed is controlled by the Aux4 knob. The speed is variable between and The governor turns on with stunt-mode 1 or 2 (idle-up and above idle limit). The throttle hold switch turns .

I've watched the Futaba governors engage when the engine is already running above the set RPM and then watched as it lowered the throttle until it matches the set RPM. I love my gy, gv-1, stator gator and my flybarred helis / Saludos cordiales, SHARE PM EMAIL GALLERY Attn:RR Quote: PM 22 months ago 0 Post Yeager. CiteSeerX - Document Details (Isaac Councill, Lee Giles, Pradeep Teregowda): 4Thank you for purchasing a Futaba GV-1 governor. To ensure safe use, please read this manual thoroughly before using your new governor. After reading this manual, store it in a safe place. FOREWORD The GV-1 is an engine governor for model helicopters. The governor automatically maintains constant rotor www.doorway.ru to. below), your hobby dealer, or the Futaba Service Center. *S-FHSS: Super- Futaba Frequency Hopping Spread Spectrum Owner's Manual and Additional Technical Help This manual has been carefully written to be as helpful to you, the new owner, as possible. There are many pages of setup procedures and examples.

Futaba GV-1 Governor. Futaba GV-1 Governor. Tested and works as it should. Comes Complete in its original packaging. The Set Includes: Instruction Manual. Minature Screwdriver. Magnets. Sensor Mounting Brackets. using your new governor. After reading this manual, store it in a safe place. FOREWORD The GV-1 is an engine governor for model helicopters. The governor automatically maintains constant rotor www.doorway.ru to load changes (reaction to torque) by suppressing variations in the engine speed. The GV-1 works very well in all maneuvers, from hovering to flying. GV-1 Governor Setup. Introduction. As far as I know, Futaba introduced the first device that could be used to govern the engine speed on a model helicopter. It was the GV It consists of a controller and a separate hall effect RPM sensor. Although it has been out of production for many years, it is still a very popular device for use on model.