Fusion digital power designer user manual

 · Fusion Digital Power is the Graphical User Interface (GUI) used to configure and monitor Texas Instruments digital power controllers and sequencer/health monitors. Main features: Configure the control law accelerator (CLA) .  · FUSION_DIGITAL_POWER_DESIGNER Downloads. Overview. Fusion Digital Power™ is the Graphical User Interface (GUI) used to configure and monitor select Texas Instruments digital power controllers and sequencer/health monitors. The application uses the PMBus protocol to communicate with the device over serial bus by way of a TI USB adapter. The AD has 3 flash modes: Manual, TTL, and Multi (Stroboscopic). Manual outputs the user’s choice of power, modeling light, first or second curtain sync, etc. Multi controls the stroboscopic rate up to 90 times (90 Hz). TTL takes advantage of the flash head’s built-in .

The easiest way is to use a TI USB interface adapter and TI's Fusion Digital Power Designer tool: The connector on the ZC board can be on the top or bottom side depending on what board revision you have. After opening the tool, Vadj can be set by modifying Vout on UCD@53, rail #1. TI's Fusion Digital Power Designer graphical user interface (GUI) facilitates UCDcontrolled power-converter designs. By talking to the GUI through the PMBus, you can monitor the power-supply operating status, configure operation parameters and tune the control loop on the fly. FUSION_DIGITAL_POWER_DESIGNER Downloads. Overview. Fusion Digital Power™ is the Graphical User Interface (GUI) used to configure and monitor select Texas Instruments digital power controllers and sequencer/health monitors. The application uses the PMBus protocol to communicate with the device over serial bus by way of a TI USB adapter.

Fusion Digital Power™ is the Graphical User Interface (GUI) used to configure and monitor select Texas Instruments digital power controllers and sequencer/health monitors. The application uses the PMBus protocol to communicate with the device over serial bus by way of a TI USB adapter. Refer to the Fusion Digital Power Designer User Manual for more information. The Manual is available for review when the software is first initialized; it is also available through the Help menu. The GUI software TI-Fusion-Digital-Power-Designerand the EVM hardware require the following workstation platform (host). Fusion Digital Power is the Graphical User Interface (GUI) used to configure and monitor Texas Instruments digital power controllers and sequencer/health monitors. Main features: Configure the control law accelerator (CLA) coefficients through an interactive design tool.